Do you know what you need to do before you start a floor scrubber?

Before you start, follow these steps:

1. Check the battery. If the battery is insufficient, please charge it.

2. Make sure the sewage tank is empty. Drain the sewage tank first if necessary.

3. Through the water inlet under the seat, fill the clean water tank with the appropriate concentration of low-foam detergent. Leave a space of at least 5CM height between the water surface and the water intake.

4. Choose a brush or dial suitable for cleaning the floor.

5. Ensure that the suction strip is firmly hung and connected to the suction pipe. Ensure that the rear water-absorbing rubber strip is not worn out.

If the operator is using the machine for the first time, please choose a larger space for training operation of the machine, please empty the sewage tank before adding water to the clean water tank each time.

In order to achieve the best cleaning results and extend the service life of the machine, please follow the following simple rules to use the machine.

1. Please tidy up the work area first, and then move away from obstructions as much as possible.

2. Please try to work at a time with fewer personnel to avoid contamination of the ground again.

3. Run the machine as straight as possible when cleaning.

4. The large area to be cleaned can be divided into several rectangular areas for separate cleaning. If necessary, use a mop or rag to dry areas that cannot be reached by the large floor washer.

Share: